Table of Contents
Advertisement
Options
2.3.3 Chart drive system
Speed setting
Step size
Inaccuracy time base
Pulse width
External drive
External division factor :
Recording paper
Paper length
Paper life
2.3.4 External available I/O (remote control is optional)
The following functions are available at the15 pin sub D connector, which is located at the rear side of the
recorder.
Penlift channel 1 (option)
Penlift channel 2 (option)
Start of plot/major gridmark
Go to major gridmark
Servomarker channel 1
Servomarker channel 2
Home
Chart stop
External chartdrive pulse input
ground
Depending on which options have been installed and which have not been installed, the following external
options may be available as well:
serial out ch.1/2 (9600 Baud)
POC on/off ch.2
Chapter 5 OPTIONAL EXTERNAL FUNCTIONS gives more information on these functions and the effect
of installing options.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Instruction manual BD 11/11E / 12/12E
:
- POC module ch.2 with RS232-C output
- POC module ch.1 with RS232-C output
- Electrical pen lift channel 1 and 2 independent, plus remote
control connector
:
0.1-0.2-0.5-1-2-5-10-20 mm/min or mm/sec
:
0.05 mm
:
better than +/- 50 ppm
:
greater than 1 µs
:
TTL pulse input maximum frequency 8 kHz (option)
1 - 12000 selectable by chart speed setting
:
chart roll according to DIN 16230
:
25 metres
:
4100 hours at lowest chart speed
20 minutes at highest chart speed
Kipp & Zonen B.V.
9
Advertisement
Table of Contents
