Installation; Included With The Product - Kipp & Zonen SMP series Instruction Manual

2. Installation

.
Please follow the instructions in this section carefully for the mechanical and electrical installation of the SMP series pyranometers.
Do not turn on power to the instrument until instructed to do so.
Note Do not connect the instrument to a computer until instructed to do so.
Note Do not turn on power to the operating computer until instructed to do so.

2.1 Included with the product

Check the contents of the shipment for completeness (see below) and note whether any damage has occurred during transport.
If there is damage, a claim should be filed with the carrier immediately. In the case of damage and/or the contents are incom-
plete, contact your local Kipp & Zonen representative or e-mail the Kipp & Zonen customer and product support department at:
support@kippzonen.com
Although all SMP radiometers are weather-proof and suitable for use in harsh environmental conditions, they have some
delicate mechanical parts. Please keep the original packaging for safe transport of the radiometer to the measurement site, or
for use when returning the radiometer for calibration.
The following items are included with SMP pyranometers:
1 Smart Pyranometer
2 Sun screen
3
Optional cable, pre-wired with 8-pins connector or connector only for customer cable
4
Calibration certificate
5 Instruction sheet
6
Pyranometer fixing kit SMP3; 2 each of stainless steel M5 x 30, M5 x 40 and M5 x 50 mm screws, nut, flat washer
Pyranometer fixing kit SMP6 to SMP22; 2 each of stainless steel M5 x 80 mm screw, nut, flat washer, nylon insulation ring
7 2 Dessicant bags (SMP11 only)
2
1
5
3
7
6
2x
2x
2x
2x
13
4