The Stacker Is Not Closed Automatically - Fujitsu FI-800R Operator's Manual

The Stacker is Not Closed Automatically

Check the following points
● Did any paper jam occur? (page 117)
If the problem persists, refer to
(page 140) and take measures accordingly. If the problem still persists, check each item in
Contact the Scanner Service Provider (page 141)
purchased this product. Refer to the contact information in the Contact List if supplied with this product, or
refer to the contact information in the Contact for Inquiries section if provided in Safety Precautions
supplied with this product, and then make an inquiry.
●
Did any paper jam occur?
Solution
If a paper jam did occur, first open the ADF, and then push the parts on either side of the stacker to close
the ADF so that the stacker will also be closed automatically.
For details about the solution for paper jams inside the ADF, refer to
The First Measures to Take When You Encounter any Errors or Troubles
first, then contact the distributor/dealer where you
117
Troubleshooting
Before You
When a Paper Jam Occurs (page 103).