Fujitsu TWAIN 32 Manual page 62

When using a scanner, the following message may be displayed.
If this message appears, replace consumables following the instructions
below.
< If replacing consumables immediately >
1. Check [This message not display again.]
2. In cases where consumables are replaced after completing all documents
being scanned, click [Ignore]. In cases where scanning is stopped for an
immediate replacement, click [Cancel].
3. Following the operator's guide of the device, replace the consumables.
4. Select [Page counter] from [Device setup], click [Clear] button to reset the
consumables counter.
< If replacing later (immediate replacement is impossible) >
1. If it is not necessary to display this message again, check [This message
not display again]*. If it is necessary to display this message again after
scanning xxx pages, check [Warns again after scanning xxx pages].
2. If the scanning is continued, click [Ignore] and close the message. If the
scanning is stopped, click [Cancel] and close the message.
1. Replace consumables as soon as possible or when this message
appears next time.
2. After the replacement, click [Clear] of [Device Setup] under [Page
Counter] to reset the consumables counter.
(* If [This message not display again] is checked, this message will not
appear before the consumables counter is reset.)
♦ Offset adjustment
If the written document and the desired read position for scanning are
different, fine adjustment is possible. At shipment, the offset has been
adjusted to an optimum value within a certain range. Therefore, adjustment
59