Leuze electronic DDLS 508i Original Operating Instructions page 24

Mounting
Fig. 4.2: Mounting with offset housings
Overview:
• The alignment laser projects a target spot on the opposing side.
In addition to the target spot, the beam optics produce four individual laser spots that are projected on
the floor.
• The device is aligned vertically and horizontally with two alignment screws using the integrated level
and the laser spots that are projected on the floor.
• The second device is mounted on the horizontally opposing target spot with the aid of the supplied
drilling template.
Ä Depending on mechanical conditions, mount the stationary or mobile device with four M5 screws via
the fastening holes in the mounting plate of the device.
ð Check the vertical mounting with a separate level.
ð Place the level on the edge of the mounting plate.
Ä Connect the device electrically (see chapter 5 "Electrical connection"). The AUT LED (continuous light)
indicates that the start-up phase of the device after "POWER on" has been concluded.
ð After the start-up phase, the operating mode can be changed.
Ä Switch on the alignment laser. Activate the LAS (Alignment laser) operating mode to switch on the
alignment laser (see chapter 6.1 "Setting the operating mode").
NOTICE
Data transmission is active while changing the operating mode and with activated alignment
laser.
Leuze electronic GmbH + Co. KG
30 mm
DDLS 508i 24