Setting Up The Printer To Fax - Lexmark MB2236 User Manual

Set up, install, and configure
Printer port
5 Power cord socket Connect the printer to a properly grounded electrical outlet.

Setting up the printer to fax

Setting up the fax function
Notes:
•
Some connection methods are applicable only in some countries or regions.
•
If the fax function is enabled and not fully set up, then the indicator light may blink red.
•
If you do not have a TCP/IP environment, then use the control panel to set up fax.
Warning—Potential Damage: To avoid loss of data or printer malfunction, do not touch cables or the printer
in the area shown while actively sending or receiving a fax.
Using the control panel
1
From the control panel, navigate to:
Settings > Device > Preferences > Run Initial Setup
For non-touch-screen printer models, press
2
Turn off the printer, wait for about 10 seconds, and then turn on the printer.
3
On the Fax setup screen, configure the settings.
4
Finish the setup.
Using the Embedded Web Server
1
Open a web browser, and then type the printer IP address in the address field.
Notes:
•
View the printer IP address on the home screen. The IP address appears as four sets of numbers
separated by periods, such as 123.123.123.123.
Function
to navigate through the settings.
22