Setting Up The Printer To Fax - Lexmark MX931 MFP User Manual

Set up, install, and configure
Adjusting the Voice Guidance speech rate
1
From the home screen, touch Settings > Device > Accessibility > Speech Rate.
2
Select the speech rate.
Adjusting the default headphone volume
1
From the home screen, touch Settings > Device > Accessibility.
2
Adjust the headphone volume.
Note: The volume resets to the default value after the user exits Accessibility mode or when the printer
wakes from Sleep or Hibernate mode.
Adjusting the default internal speaker volume
1
From the home screen, touch
2
Adjust the volume.
Notes:
•
If Quiet Mode is enabled, then audible alerts are turned off. This setting also slows the printer
performance.
•
The volume resets to the default value after the user exits Accessibility mode or when the printer wakes
from Sleep or Hibernate mode.
Enabling spoken passwords or personal identification numbers
1
From the home screen, touch Settings > Device > Accessibility > Speak Passwords/PINs.
2
Enable the setting.

Setting up the printer to fax

Supported fax
•
Analog fax
Note: Needs an installed fax card. For more information, contact the place where you purchased the
printer.
•
etherFAX
Note: Needs a subscription. For more information, go to
the place where you purchased the printer.
•
Fax over IP (FoIP)
Note: Needs an installed license bundle. For more information, contact the place where you purchased
the printer.
•
Fax server
.
https://www.etherfax.net/lexmark
39
or contact