Table of Contents
Advertisement
Update the Connect Sensor+ configuration
Restore a Connect Sensor+ configuration
You can restore the configuration for a Connect Sensor+ from a backup saved on your computer or
choose to restore these settings to the default configuration: all the analog, digital, and serial
settings, the device profile, and all of the automation control settings.
The configuration is restored during the next time that the Connect Sensor+ wakes up and connects
to SkyCloud, either at the
1.
Log into
the Connect Sensor+ web UI on SkyCloud
2. In the Options section, click System Tools. The Tools and Utilities page displays.
3. Click Backup/Restore. The Load Configuration page displays.
4. From the Select an Option section, click Install.
5. Determine the configuration type you want to install: from a configuration back up file or to
restore the configuration to default settings.
Previously saved back up file
n
Restore to default settings
n
Force a full configuration update on a Connect Sensor+
Forcing a full configuration update overwrites the entire Connect Sensor+ configuration on the device
based on the Connect Sensor+ configuration stored in SkyCloud.
The update happens during the next time that the Connect Sensor+ wakes up and connects to
SkyCloud, either at the
Digi recommends only forcing a configuration update when the
Summary page shows as Synced but the device configuration is not properly synced and
you have physical access to the device.
1.
Log into
the Connect Sensor+ web UI on SkyCloud.
2. In the Services section, click SkyCloud Services. The SkyCloud Service Configuration page
displays.
Welcome to Digi SkyCloud
scheduled wake time
a. In the Select a Location section, click Local Storage.
b. Click Choose File and navigate to a
c. Click Open.
d. Click Submit to store the install instruction. The configuration install occurs
the next time that the Connect Sensor+ wakes and connects to SkyCloud.
a. In the Select a Location section, click Provided.
b. From the Select a Configuration list box, select Blank Configuration.
c. Click Submit to store the install instruction. The configuration install occurs
the next time that the Connect Sensor+ wakes and connects to SkyCloud.
scheduled wake time
or if it is
Restore a Connect Sensor+ configuration
or if it is
done
manually.
saved back up
done
manually.
file.
Sync Status
in the Device
65
Advertisement
Table of Contents
