Step 2: Wire A Power Supply To The Z45 Controller And Power The Device - Digi SkyCloud Z4500 Series User Manual

Assemble the Z45 Controller hardware
Equipment Description
Power A power supply that has one end with two wires exposed and stripped, which are
supply then wired to the Z45 Controller.
Note
connector pigtail kit (PN 76002127) or a DIN mount power supply (PN 760002129).
The female barrel connector pigtail provides an interface to power supplies
equipped with a male barrel connector.
For information about wiring the barrel connector pigtail power supply, see
the Z45 Controller using a barrel connector
LPS (Limited power source) power supply required
Cellular Two cellular antennas are needed.
antennnas:
2
Second The Z45 Controller has two SIM card slots. At least one SIM card is required for
SIM card cellular connection.
An M2M SIM card is inserted in Slot A by default. Check with your system
(Optional)
administrator to confirm that the
activated.
The second SIM card is optional and is used for redundancy.
NEXT STEP: Proceed to
Step 2: Wire a power supply to the Z45 Controller and power the
device
An external power supply must be wired to the device and plugged into a main power supply. You can
supply your own power supply or
Note Some Z45 Controller SKUs come with a power supply: a female barrel connector pigtail kit (PN
76002127) or a DIN mount power supply (PN 760002129). The female barrel connector pigtail provides
an interface to power supplies equipped with a male barrel connector.
For information about wiring the barrel connector pigtail power supply, see
using a barrel connector
LPS (Limited power source) power supply required
Welcome to Digi SkyCloud

Step 2: Wire a power supply to the Z45 Controller and power the device

Some Z45 Controller SKUs come with a power supply: a female barrel
Use a UL listed power supply with an LPS output, rating of 9-24 V DC with 12
n
Watts output minimum.
As an alternate – Listed/CN, ITE Power Supply, input rated 100-240 V AC, 0.33
n
A minimum; output rated 9-24 V DC, 0.5 A minimum.
Unit must be marked "LPS."
n
Power supply shall be suitable for the ambient temperature where device is
n
installed.
Step 2: Wire a power supply to the Z45 Controller and power the
purchase one
pigtail.
pigtail.
M2M SIM card in the Z45 Controller has been
from Digi.
Power
device.
Power the Z45 Controller
20