Pyramix With Uf1 - Tutorial; Ssl 360° Setup; Pyramix Setup - Solid State Logic SSL UF1 User Manual

Pyramix with UF1 - Tutorial

The following tutorial guides you through configuring and using the default Pyramix profile on LAYER 1 of UF1. If you wish to
configure Pyramix on a different layer, please refer to the DAW Communication section of this User Guide to ensure your DAW is
configured for the correct SSL V-MIDI ports..
SSL 360° Setup
1. Open the SSL 360° application on your computer. Go to the HOME page and check that your UF1 has been detected by SSL
360°.
2. Go to the UF1 page and set Layer 1 to Pyramix using the drop-down list. If Pyramix is not available from the drop-down list it
is because you have not configured it as DAW 1 on the
STEP 1 : Open SSL 360° application.
Check your UF1 has been detected.

Pyramix Setup

3. Open Pyramix and access the Settings > All Settings menu. Go to Remote Control > Controller and click on Add.
4. Enter a name for the controller and set the Driver to OASIS.
5. Click on the Properties button.
6. In the OASIS Configuration window, set the Transport to EMC.
7. Click on the Properties button.
8. Set SSL V-MIDI Port 1 for both Midi In and Midi Out ports. In this list, ensure that any SSL V-MIDI Ports you need are assigned
9. In the Controller drop-down menu, select SSL UF8 MackieCtrl. Press OK to close the different windows.
STEP 3: Access the Settings > All Settings menu. Go
to Remote Control > Controller, click on Add.
SSL UF1 User Guide
CONTROL SETUP page - ensure you do this first.
STEP 2 : Select the default Pyramix
DAW profile from the UF1 page.
STEP 4: Enter a name for the controller and set the
Pyramix Tutorial
Driver to OASIS.
107