Table of Contents
Advertisement
Series 3050 Btu Monitor
Wall Mount Installation
The Series 3050 wall mount is designed to mount onto a wall with four bolts or screws. The mounting hole pattern and box
dimensions for the Series 3050 NEMA4 waII mount are shown in Figure 2.
Electrical Installation
Power Supply Wiring
The Series 3050 Btu Monitor requires 12-24 VDC/VAC to operate. Check the Specifications on page 29 for DC current draw
and AC Volt-Amp requirements.
A fused circuit is always recommended.
Connect the positive of the power supply to the Series 3050 terminal marked (ACL/DC+), and connect the negative of the
power supply to the Series 3050 terminal marked (ACC/DC-).
If a Badger Meter Data Industrial plug-in power supply (Model A1026, A-503) is being used, connect the black-white wire to
the terminal marked (ACL/DC+) and the black wire to the terminal marked (ACC/DC-).
Page 8
Figure 2: Wall Mount and Dimensions
Figure 3 ( Power Supply Wiring)
Ground wire should be heavy gauge and as short as possible
Earth
3
POWER
LV AC/DC(-) 2
LV AC/DC(+) 1
Figure 3: Power Supply Wiring
(+) (-)
( Line) (Com)
12-24VDC
12-24VAC
OR
Power
Power Supply
Supply
Earth
or
Panel
Ground
6-11
Advertisement
Table of Contents
