Table of Contents
Advertisement
Series 3050 Btu Monitor
USB Communication
If the Data Industrial Series 3050 Btu Monitor is ordered with an Analog Output Option card, a five-pin USB connector is also
included. As much as possible the commands mimic the use of the Front Panel controls.
To use this feature the following are required.
1. PC with USB ports and Windows HyperTerminal or other communications software
2. FTDI Virtual COM port drivers http://www.ftdichip.com/FTDrivers.htm
3. USB 2.0 A to Mini-B 5-pin cable
To communicate using HyperTerminal, use the following procedure.
1. Make sure that the Series 3050 has a Mini-B five-pin connector on the back panel. (The Series 3050 must have an Analog
Output Option card installed and will be marked Series # 3050-1x.)
2. Be sure that the appropriate FTDI Virtual COM port drivers are installed on you computer.
3. Plug the USB 2.0 A end of the cable into an available USB port on your computer. Plug the Mini-B five-pin end into the
back of the Series 3050.
Page 24
6-11
Advertisement
Table of Contents
