SCOPE OF THIS MANUAL
This manual contains instructions for installing, operating and programming the IS-4000 flow meter
IMPORTANT
Read this manual carefully before attempting any installation or operation. Keep the manual accessible for future reference.
SAFETY PRECAUTIONS AND INSTRUCTIONS
Some procedures in this manual require special safety considerations In such cases, the text is emphasized with the
following symbols:
Symbol
Explanation
Warning indicates the potential for severe personal injury, death or substantial property damage
WARNING
Comply with the instructions and proceed with care
Caution indicates the potential for minor personal injury or property damage Comply with the
instructions and proceed with care
Before installing or using this product, please read this instruction manual thoroughly Only qualified personnel should install
and/or repair this product If a fault appears, contact your distributor
Installation
•
Do not place any unit on an unstable surface that may allow it to fall
•
Never place the units above a radiator or heating unit
•
Route all cabling away from potential hazards
•
Isolate from the mains before removing any covers
Power Connection
•
Use only the type of power source suitable for electronic equipment If in doubt, contact your distributor Ensure that any
power cables are of a sufficiently high current rating
•
All units must be earthed to eliminate risk of electric shock Failure to properly earth a unit may cause damage to that unit
or data stored within it
Protection Class
The device has protection class IP 67 and needs to be protected against dripping water, water, oils, etc
Setup and Operation
Adjust only those controls that are covered by the operating instructions Improper adjustment of other controls may result in
damage, incorrect operation or loss of data
Cleaning
Switch off all units and isolate from mains before cleaning Clean using a damp cloth Do not use liquid or aerosol cleaners
Repairing Faults
Disconnect all units from power supply and have it repaired by a qualified service person if any of the following occurs:
•
If any power cord or plug is damaged or frayed
•
If a unit does not operate normally when operating instructions are followed
•
If a unit exposed to rain/water or if any liquid has been spilled into it
•
If a unit has been dropped or damaged
•
If a unit shows a change in performance, indicating a need for service
August 2021
HYB-UM-02509-EN-06
Scope of This Manual
Page 5