Installation; Set Up And Operation; Control Modes; One Cameleon Flood (Auto Program) - SHOWTEC Cameleon Flood 15 Q4 V4 Manual

Cameleon Flood 15 Q4

Installation

Remove all packing materials from the Cameleon Flood 15 Q4. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

Control Modes

There are 5 modes:

One Cameleon Flood (Auto program)

01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Cameleon Flood is not connected with a DMX cable, it functions as a stand-alone
device. Please see page 15 for more information about the Auto program.

One Cameleon Flood (Built-in programs)

01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Cameleon Flood is not connected with a DMX cable, it functions as a stand-alone
device. Please see page 15 for more information about the Built-in programs.

One Cameleon Flood (Manual Color mode)

01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Cameleon Flood is not connected with a DMX cable, it functions as a stand-alone
device. Please see page 16 for more information about the Manual Color mode.
Ordercode: 42671
• Auto program
• Built-in programs
• Manual Color mode
• Master/slave
• DMX-512 (4CH, 6CH, 10CH)
9