3.2.1
Electrical Specifications
Table 3.3: Electrical Specifications
Item
Line drawing accuracy:
Operating voltage
Chattering
Interface
Power consumption
Report rate
3.2.2
Pin Assignment and Description
There are 2 x interfaces — USB and I2C (Optional). Connectors and Pin assign-
ments are displayed below.
Specifications
1pt +/- 2mm offset /10mm
Touch (point) accuracy: 1pt +/- 2mm
3.5V~5.5V.Typical 5V
Less than 25 ms
USB (I2C Optional)
Active Mode: < 90mA
Idle Mod : depends on firmware
> 100Hz
Figure 3.1 Connectors and Pin Assignment
21
IDK-1115WP-45FHA2 User Manual