Mechanical Dimensions And Construction; General; Mechanical Performance; Electrical Specifications - Advantech IDK-1110P-50XGB1 User Manual

3.1

Mechanical Dimensions and Construction

3.1.1

General

The projective capacitive touch screen adopts a COF (Chip on FPC) design.

Therefore, an extra touch control board is not required. This communicates with
a PC system directly through USB connectors. This superior design is sensitive,
accurate, and user friendly.
Anti-UV projective capacitive touch panel is designed by Cover Lens-Film con-

struction
3.1.2

Mechanical Performance:

Surface Hardness: Mohs 5

Cover Lens Thickness: 1.10 mm (.04 in)

Overall Thickness: 1.50 ±.2 mm (.05 ± .07 in)

Static Force Requires Breaking the Glass: >20kgf

Falling from a steady state, a 130 g (0.28 lb) steel ball freely drops on to the

center of the touch panel from a height of 440 mm (17.3 in) height once, the
touch panel will not break during the first impact.
Note!
The test is for the touch panel only, not including the mechanical.
Tail Type: COF (Chip on FPC tail)

– Controller is 80H46 IC on the FPC tail
– FPC Tail Bending Radius: R2.5mm
– Bending endurance: 180deg for 10 times
– Holding force for tail, peeling upward 90deg with 500gw without impact to
electric performance.
– Connector Pins & Pitch: 5pins/pitch 1.25 mm (.049 in)
Top Surface Finish Type: Clear

3.2

Electrical Specifications

3.2.1

Specifications

Input mode: Finger

Activation Force: Zero force

Number of sensing line: 42 (including 2 shielding lines)

Number of driving line: 30 (including 2 shielding lines)

Linearity: Line Drawing Accuracy:

– 1pt +/- 1mm offset / 10mm
– Touch (point) accuracy: 1pt +/- 1mm
Interface: USB 2.0

Firmware resolution: 16384x16384

Response time: Average < 25ms

Report Rate(points/sec): >100 Hz (Typical)

Power consumption: Active mode < 90mA @ 5Vdc

IDK-1110P-50XGB1 User Manual 24