Table of Contents
Advertisement
•
Avoid dusty areas.
•
Choose a location that has good air circulation and is
not exposed to direct sunlight.
•
Avoid noisy electrical power sources (e.g., power
generators).
•
Do not install in a location where there is large
temperature variability or high humidity.
•
Position the instrument so that it is easy to unplug from
the power source.
•
Do not place next to heat sources.
•
Do not use near flammable gases or liquids.
•
Do not place near other electrically sensitive
instruments.
2. Hardware Overview
Figures 3 and 4 show the front of the Maxwell
instrument.
Figure 3. Front of Maxwell
Promega Corporation
2800 Woods Hollow Road • Madison, WI 53711-5399 USA
Toll Free in USA 800-356-9526 • Phone 608-274-4330
Maxwell
®
16 MDx
®
16 MDx Instrument.
®
16 MDx Instrument Technical Manual
Figure 4. Touch Screen and Keypad. The touch screen and the
keypad for use in navigating through the various screen displays
for the Maxwell
®
16 MDx Instrument. The same button selections
are available on the keypad and the screen. Both sets of buttons
can be used to navigate within and between screens. The Back and
Run/Stop buttons allow navigation between screens. The Up and
Down buttons are for navigation within a screen.
Figure 5. Power On/Off switch on the rear of the Maxwell
MDx Instrument. The rear of the instrument showing the On/Off
switch and where to connect the power cable. A 3 amp time-lag
fuse is located next to the power switch.
Figure 6. Communications ports on the side of the instrument.
This side view shows the communication ports for the instrument.
The USB port is used to attach the bar code reader.
®
16
RS-232 port
USB in port
SD card slot
Power cord
receptacle
On/off switch
part# TM320
4
rev. 9/09
Advertisement
Table of Contents
