Table of Contents
Advertisement
I.E. Environmental Requirements
Power Requirements:
Temperature:
Humidity:
The Maxwell
instrument on a clean, level surface. To avoid shortening the expected lifespan of the instrument, install
in a location that meets the following criteria:
•
Locate on a sturdy, level surface.
•
Avoid dusty areas.
•
Choose a location that has good air circulation and is not exposed to direct sunlight.
•
Avoid noisy electrical power sources (e.g., power generators).
•
Do not install in a location where there is large temperature variability or high humidity.
•
Do not position the instrument so that it is difficult to unplug from the power source.
•
Do not place next to heat sources.
•
Do not use near flammable gases or liquids.
•
Do not place near other electrically sensitive instruments.
II.
Hardware Overview
Maxwell
Display panel
and keypad
Door
handle
Promega Corporation · 2800 Woods Hollow Road · Madison, WI 53711-5399 USA · Toll Free in USA 800-356-9526 · Phone 608-274-4330 · Fax 608-277-2516 · www.promega.com
Part# TM274
Page 8
100–240VAC, 50–60Hz, 2.1A
5–40°C
up to 80% relative humidity
16 Instrument is intended for indoor use only. Wipe up spills immediately. Install the
®
®
16 Instrument Front
Maxwell
®
16 Instrument Back
Power
connection
Power
switch
Label
Serial port. Connect to
computer using the RS-232
Cable to obtain firmware upgrades.
Printed in USA.
Revised 6/08
Advertisement
Table of Contents
