Anchor Procedure - Hammer Strength HDW-SQST Owner's Manual

Anchor Procedure

1. Place unit into position to be mounted and cycle unit to set its stance.
2. Wearing protective glasses, drill down into flooring perpendicularly to the required depth, ensuring that the foot
thickness of the unit is being accounted for; refer to Anchor Specifications and Foot Dimensions.
NOTE: Use 3/8" size bit for Imperial anchors and 10mm for Metric anchors.
3. Clear out debris from hole.
4. NOTE: This step only applies to dynamic anchors. Do not hammer static anchors.
Insert anchor assembly and hammer until flush against upright's base plate.
Item
1
2
Item
1
2
3
Page 67 of 69
Description
Drill with Concrete Bit
Upright
Description
Hammer
Anchor Assembly
Base Plate
Qty.
1
1
Qty.
1
1
1