Maintenance Procedures; Maintenance Schedule - Hammer Strength HDW-SQST Owner's Manual

5. Maintenance Procedures

Maintenance Schedule

ACTION
CLEAN
Guide Rods
Shrouds
Hand Grips
WAX
Frames
INSPECT
Accessories
Paint
Cable
Hardware
Frame
Shrouds
LUBRICATE
Guide Rods
Clean
• Guide rods with a cotton cloth.
Wax
• Frames with a standard, non-abrasive, wax finish.
Inspect
• Cables. Look for wear or damage and proper tension. Pay close attention at bends and attachment points.
• Hardware. Check for loosening. Tighten as required.
• Frames. Inspect for wear and damage.
• For paint chips. Fill in immediately with manufacturers touch-up paint.
• Jam nut at top of weight stack for tightness.
Lubricate
• Lubricate guide rods with Break-Free® brand lubricant (part number SK50-P0005-0000). Apply the lubricant to a
cotton cloth, and then run the cotton cloth up and down the guide rods as needed.
NOTE: Only a few drops of lubricant are required for each guide rod.
Once a Day
• Wipe down upholstery with a mild soap and water or comparable all purpose cleaner.
• Visually inspect cables for wear at and around connections and along the entire length of the cable. Always replace
at first sign of wear.
Once a Week
• Visually inspect all hardware for loosening, tampering or wear.
• Check jam nut at top of weight stack for tightness.
• Inspect all accessories, connecting links, and carabiner clips for wear.
DAILY WEEKLY
X
X
Page 56 of 69
MONTHLY
X
X
X
X
X
X
AS NEEDED
X
X
X