Anchor Types; Anchor Specifications - Hammer Strength HDW-SQST Owner's Manual

Carpeting
If bolted down to carpet flooring, be sure to use a box cutter knife to cut the carpet threads around each foot. This will
help avoid the carpet threads from being wrapped around and pulled by the drill bit.
Competitor Product
The bolt down guidelines and procedures for Life Fitness products were determined by the company's Engineering
and Installation Development groups. These guidelines include which anchors to use and positioning of the anchors
are required for Life Fitness product.
• Life Fitness does not have that level of specification or engineering input for competitive product.
• Life Fitness installation teams are not permitted to anchor competitor equipment.
Drilling
It is also recommended to drill an additional 1/2" (12.7 mm) of depth beyond the length of the fastener being used to
ensure that debris does not block the entry of the anchor.
• This can be done by marking your drill bit with a piece of tape.
• While it is recommended that a vacuum be used to clean up debris, this will not account for all the debris that will
settle at the bottom of the drilled hole.

Anchor Types

Dynamic Anchor
Static Anchor

Anchor Specifications

1
Dynamic Anchor Minimum
Concrete
Thickness
KB-TZ2 3/8" x 5"
HST3 10mm x
100mm
130mm
1
Static Anchor Minimum
Concrete
Thickness
KB-EZ 1/4" 4-1/8"
HUS-H 6mm 100mm
2 3
Minimum Anchor
Embedment into
Concrete
4" 2-1/2"
68mm
2 3
Minimum Anchor
Embedment into
Concrete
2-1/2"
55mm
Standard Sizes
Imperial: KB-TZ2 3/8" x 5"
Metric: HST3 10mm x 130mm
Standard Sizes
Imperial: KH-EZ 3/8" x 5"
Metric: HUS-H 10mm x 130mm
4
Minimum Drill
Depth in Distance from
Concrete
Beyond Anchor Concrete Edge
1/2"
12mm
4
Minimum Drill
Depth in Distance from
Concrete
Beyond Anchor Concrete Edge
1/2"
10mm
Page 65 of 69
5
Minimum Maximum
Flooring (wood/tile/
Anchor to rubber/screed) Thickness
Between Base Plate and
or Seam: Concrete
1-3/4" 0" - 0.92"
44mm 0mm - 26mm
5
Minimum Maximum
Flooring (wood/tile/
Anchor to rubber/screed) Thickness
Between Base Plate and
or Seam: Concrete
1-3/4" 0" - 0.92"
44mm 0mm - 26mm
Drill Bit Size
3/8in
10mm
Drill Bit Size
3/8in
10mm
6
6