Change Program Password - Multitek MULTIBUS MB-09 User Manual

MULTIBUS MB-05 and MB-03 DOOR PANEL USER MANUEL
PROGRAM PASSWORD:
4-digit program password is used to define the block number from the door panel, to define the door
number etc. Initial value of program password is 7447.
In the following programming sections the program password is written as SSSS.
SSSS = Programing Password (Default 7447)

CHANGE PROGRAM PASSWORD:

The current program password + 2 + new program password is keyed in the door panel. Program
password changed.
SSSS + 2 + YYYY
Note: The password consisting of consecutive numbers cannot be entered. Your device must be
reprogrammed when you forget your program password.
Defining Whether A Doorkeeper Exists
Program password + 3 + 0 or 1 is keyed in the door panel.
SSSS + 3 + DOORKEEPER
DOORKEEPER: 0 Doorkeeper availabe. (Default 0)
DOORKEEPER: 1 Doorkeeper not available.
Identify The Door Panel Number
Program password + 0 + Door Number is keyed in the door panel.
SSSS + 0 + K
With the door no, you set how many doors are in the block. Maximum number of doors 4 types.
Opening The Outside Door With A Password
A password can be defined for each apartment.
Defining The Door Opening Password
The number of the circle to determine the password from the outer door panel is given. Press the F1 while
removing the handset from the dialed apartment.
After press the F1. At the outer door panel, first 99 keyed, followed by a 4 digit password.
99 + XYZT
Note: The password consisting of consecutive numbers (1234, 5678 etc.) cannot be entered. When a
sequential number is entered, alerted by a faulty input tone by the outside door panel. Change the
password and login again.
Example: To set the password for apartment number 2;
2 + ENT called
Removing the handset from the apartment and press F1.
Entered the panel 99 + 1453
6