Internal Cff Hba/Raid Adapter Replacement; Remove The Internal Cff Hba/Raid; Adapter - Lenovo ThinkSystem SR630 Maintenance Manual

Step 6. Align the pins on the hot-swap rear drive cage with the corresponding hole and slot in the chassis.
Then, lower the hot-swap rear drive cage into the chassis until it is fully seated.
Figure 81. Hot-swap rear drive cage installation
Step 7. Connect the cables to the system board or expansion slots. See "2.5-inch/3.5-inch drive backplane
(power)" on page 65 and "2.5-inch/3.5-inch drive backplane (signal)" on page 66.
After you finish
1. Reinstall the drives or drive fillers into the hot-swap rear drive cage. See "Install a 2.5/3.5-inch hot-swap
drive" on page 125.
2. Complete the parts replacement. See "Complete the parts replacement" on page 224.

Internal CFF HBA/RAID adapter replacement

Use this information to remove and install the internal CFF HBA/RAID adapter.
Remove the internal CFF HBA/RAID adapter
Use this information to remove the internal CFF HBA/RAID adapter.
About this task
Attention:
• Read "Installation guidelines" on page 83 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku:
https://list.youku.com/albumlist/show/id_59643656
ThinkSystem SR630 V2 Maintenance Manual
144