Lenovo ThinkSystem SR630 Maintenance Manual page 149
Hide thumbs
Also See for ThinkSystem SR630:
- Maintenance manual (182 pages) ,
- Product manual (75 pages) ,
- Quick start (2 pages)
Table of Contents
Advertisement
Procedure
Step 1.
Touch the static-protective package that contains the hot-swap power supply to any unpainted
surface on the outside of the server. Then, take the hot-swap power supply out of the package and
place it on a static-protective surface.
Step 2.
If there is a power-supply filler installed, remove it.
Figure 75. Hot-swap power supply filler removal
Step 3.
Slide the new hot-swap power supply into the bay until it snaps into position.
Figure 76. Hot-swap power supply installation
Step 4.
Connect the power supply unit to a properly grounded electrical outlet.
• For 240 V DC power supply units:
1. Turn off the server.
2. Connect one end of the power cord to the power connector on the power supply unit.
3. Connect the other end of the power cord to a properly grounded electrical outlet.
.
Chapter 4
Hardware replacement procedures
139
Advertisement
Table of Contents
