Assembly - Lenovo ThinkSystem SR630 Maintenance Manual

Step 4. Remove the LCD diagnostics panel from its assembly.
Figure 58. LCD diagnostics panel removal
a. Press down the clips as shown.
b. Pull the LCD diagnostics panel by its handle to get it out of its assembly.
After you finish
1. Install a new LCD diagnostics panel assembly or filler. See "Install the LCD diagnostics panel assembly"
on page 119.
2. If you are instructed to return the old LCD diagnostics panel assembly, follow all packaging instructions
and use any packaging materials that are provided.
Install the LCD diagnostics panel assembly
Use this information to install the diagnostics panel assembly.
About this task
Attention:
• Read "Installation guidelines" on page 83 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
• YouTube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku: https://list.youku.com/albumlist/show/id_59643656
Procedure
Step 1. Touch the static-protective package that contains the diagnostics panel assembly to any unpainted
surface on the outside of the server. Then, take the assembly out of the package and place it on a
static-protective surface.
.
Chapter 4 Hardware replacement procedures
119