• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Cmxb8e4L4PvMQ7J5PxvuOK
• Youku:
https://list.youku.com/albumlist/show/id_59643656
Procedure
Step 1.
Prepare your server.
a.
Remove the top cover. See "Remove the top cover" on page 220.
b.
Remove all the installed drives and fillers (if any) from the drive bays. See "Remove a 2.5/3.5-
inch hot-swap drive" on page 124.
c.
Record the cable connections for 7mm drives and then disconnect all cables from the
backplanes. For information about the backplane cable routing, see "2.5-inch/3.5-inch drive
backplane (power)" on page 65 and "2.5-inch/3.5-inch drive backplane (signal)" on page 66.
Step 2.
Gently press and hold the tab on the rear hot-swap drive cage as shown and remove the air baffle
from the rear hot-swap drive cage.
Figure 42. Air baffle removal
Step 3.
Disconnect the cables from the 2.5-inch rear drive backplane.
ThinkSystem SR630 V2 Maintenance Manual
102