Table of Contents
Advertisement
Chapter 2 Transport and storage
2.1 Transport and unpacking
2.1.1 Protective measures prior to transport
The following protective measures are taken before delivery of the machine from
the factory. The same protective measures should be taken, whenever the machine
is moved:
•
All synchronous machines delivered as a unit are provided with transport
locking device protecting the machine against damages during transport. The
locking device must be attached whenever the machine is transported.
•
Machined metal surfaces, such as the shaft extension, are coated with an anti-
corrosive coating before delivery.
•
The bearings are greased at the factory or during the tests prior to delivery.
This gives sufficient protection against corrosion.
•
During shipping the machine should be placed under deck.
2.1.2 Lifting the machine
Before the machine is lifted, ensure that suitable lifting equipment is available and
that personnel are familiar with lifting work. The weight of the machine is shown
on the rating plate, dimension drawing and packing list.
NOTE: Use only the lifting lugs or eyes intended for lifting the complete
NOTE: The center of gravity of machines with the same frame may vary due to
NOTE: Check that eyebolts or the lifting lugs integrated with the machine frame
NOTE: Lifting eyebolts must be tightened before lifting. If needed, the position
2.1.3 Lifting of unpacked machine
Lifting must be performed with great care and using slings long enough to assure
the lifting angle requirements,
requirements are not met, there is a risk of damage.
machine. Do not use any small additional lifting lugs or eyes available,
as they are there only for service purposes.
different outputs, mounting arrangements and auxiliary equipment.
are undamaged before lifting. Damaged lifting lugs must not be used.
of the eyebolt must be adjusted with suitable washers.
Page 13
see Figure 2-1. Lifting of unpacked machines.
If the
Advertisement
Table of Contents
