Using The Menu System; Figure 2- -21: Menu Selection - Tektronix DTG5078 Service Manual

Using the Menu System

Menu System
DTG5078 & DTG5274 Data Timing Generator Service Manual
This section describes the basic operation of the data timing generator using the
front panel keys, buttons and knob.
Pushing the front panel MENU button displays the last menu you selected on the
menu bar.
Figure 2- - 21: Menu selection
H To navigate through a pull-down menu list, use the Up or Down arrow key.
To show a submenu ("), use the Right arrow key. You can also use the knob
instead of the arrow keys to navigate through a menu list.
H If you press the Left or Right arrow key on a menu item not having any
submenu, you can navigate through the menu bar.
H Once you push the SELECT button, the menu is determined.
H To cancel the menu display, push the MENU button.
H To use the ESC key to cancel the menu display, press the ESC key twice.
When you press it only once, the menu bar is still active although the display
disappears. In this state, you can navigate through the menu bar by pressing
the Up, Down, Left, or Right arrow key.
Hint: Pressing the ALT key activates the menu bar. Then, you can make a menu
selection using the Up, Down, Left and/or Right arrow keys.
Pop-up Menu Items. In the individual data timing generator windows, selecting
the setup item and pushing the front panel SELECT button displays the pop-up
menu item(s) corresponding to the selected item. Refer to Figure 2- -23 on page
2- -55 for a pop-up menu example.
Operating Basics
2- - 53