Installation
Powering On the Data Timing Generator
2- - 6
3. Attach a blank panel to the slot.
Follow these steps to power on the data timing generator. Refer to page 2- -7 for
Windows 2000 setup.
1. Connect the proper power cord from the rear panel power connector to the
power system.
Principal
power
Switch
AC power
connector
Figure 2- - 1: Principal power switch and AC power connector
NOTE. Connect the keyboard, mouse and other accessories before applying
power to the product.
2. Turn on the principal power switch at the rear panel. (See Figure 2- -1 for
switch location.)
3. Push the front panel On/Standby switch to power on the data timing
generator (see Figure 2- -2 for the switch location).
DTG5078 & DTG5274 Data Timing Generator Service Manual