Siemens SICHARGE UC 150 Operating Instructions Manual page 59

Commissioning
7.1 Initial commissioning
Software verification
The service technician verifies and updates the versions of the following components as
needed during initial commissioning:
• Linux Siemens Charger Controller (SiCC)
• Supply Equipment Communication Controller (SECC)
• AC platform
• Output platform
• Fan control platform
• DSP platform
Verification of electrical functionality
The service technician checks the following components and functions during initial
commissioning:
• DC shutdown switch
– Press the DC shutdown switch
– Alarm message on HMI indicates DC shutdown switch actuation
– Unlock the DC shutdown switch
– Alarm message on HMI is automatically reset
• Check the functionality of AC contactors and DC contactors and the feedback of the
contactors on the HMI (optional)
Checking the charging session
NOTE
A vehicle with low SoC (< 60 %) must be available to proceed with this device.
You need to connect your laptop to the charging station to proceed with this device.
60
Operating Instructions, 10/2022, A5E50068475-AB
SICHARGE UC 150