Triumph Street Triple R Owner's Handbook Manual page 32

GENERAL INFORMATION
32
Street Triple RS and
Street Triple Moto2™ Edition
2
3
4
1
1. Engine start/stop switch
2. STOP position
3. RUN position
4. START position
5. Hazard warning light switch
6. HOME button
STOP Position
The STOP position is for emergency use.
If an emergency arises which requires
the engine to be stopped, move the
engine start/stop switch to the STOP
position.
Do not leave the ignition switch in
the ON position unless the engine is
running as this may cause damage
to electrical components and will
discharge the battery.
Note
Although the engine stop switch stops
the engine, it does not turn off all
the electrical circuits and may cause
difficulty in restarting the engine due to
a discharged battery. Normally, only the
ignition switch should be used to stop
the engine.
5
6
Caution
RUN Position
In addition to the ignition switch being
turned to the ON position, the engine
start/stop switch must be in the RUN
position for the motorcycle to operate.
START Position
The START position operates the electric
starter. For the starter to operate,
the clutch lever must be pulled to the
handlebar.
Note
Even if the clutch lever is pulled to the
handlebar, the starter will not operate
if the side stand is down and a gear is
engaged.
Hazard Warning Lights
To turn the hazard warning lights on
or off, press and release the hazard
warning light switch.
The ignition must be switched ON for
the hazard warning lights to function.
The hazard warning lights will remain on
if the ignition is switched OFF, until the
hazard warning light switch is pressed
again.
HOME Button
The HOME button is used to access the
main menu on the instrument display.
Press and release the HOME button
to select between the main menu and
instrument display.
All messages
the instrument
acknowledged by pressing the Joystick
center before the HOME button can be
operated.
that appear in
display must be