Triumph Street Triple R Owner's Handbook Manual page 161

To inspect the front brake fluid level:
Check the level of brake fluid visible
▼
in the MIN and MAX section of the
reservoir.
The brake fluid level in the reservoir
▼
must be kept between the MAX
and MIN level lines (reservoir held
horizontal).
To adjust the brake fluid level:
Loosen the reservoir cap retaining
▼
screws and remove the reservoir
cap and the diaphragm seal.
Fill the reservoir to the MAX level
▼
line using new Triumph Performance
DOT 4 brake fluid from a sealed
container.
Install the diaphragm seal into the
▼
reservoir cap and make sure that
the holes for the fasteners in the
reservoir cap and the diaphragm
seal are correctly aligned.
1
3
ckks
1. Reservoir cap
2. Diaphragm seal
3. Reservoir cap retaining screw holes
Install the reservoir cap retaining
▼
screws into the reservoir cap and
diaphragm seal assembly.
Hold
▼
and position the reservoir cap,
diaphragm seal and reservoir cap
retaining screws onto the reservoir.
1
ckkr
1. Reservoir cap, diaphragm seal and
reservoir cap retaining screws assembly
2. Reservoir
If the reservoir cap retaining screws
are over tightened this can result in a
brake fluid leak.
2
A dangerous riding condition leading
to loss of motorcycle control and an
accident could result if this warning is
3
ignored.
1. Reservoir cap retaining screws
Tighten the reservoir cap retaining
▼
screws to 6 lbf in (0.7 Nm).
MAINTENANCE
the assembly
2
Warning
1
161
together