Table of Contents
Advertisement
GETTING STARTED
Integrating Remote I/O Stations with Com Unit LB/FB8X09* / LB/FB8X05*
4.6. Store Data in the Com Unit
When first commissioning the remote I/O station, it is recommended that the line fault
detection (LFD) is deactivated to prevent line faults from being displayed for
unoccupied channels of the I/O modules. This can be activated again at a later point
in time (see section 4.6). Select:
1.
Com unit → Disconnect.
2.
Com unit → Additional functions → LFD of All Channels OFF.
Finally, store the current configuration data in the com unit:
1.
on the com unit to establish the connection to the com unit.
2. Select
If a communication error appears at this point due to the firmware used on
the com unit, then unsupported functions can be disabled:
Com unit → Parameter → Parameterization → Select firmware-
dependent functions:
Com unit → Store to Device:
24
Advertisement
Table of Contents
