Table of Contents
Advertisement
GETTING STARTED
Integrating Remote I/O Stations with Com Unit LB/FB8X09* / LB/FB8X05*
4.1.2. Add a Com Unit
1.
on Interface → Disconnect to ensure that the connection to the
previously added interface is disconnected.
2.
on the Interface and select Add device to add the com unit being used:
3. When prompted, enter the "Station Address". This is the PROFIBUS
address of the com unit. This must match the specification in the
PLC. The PROFIBUS address of the com unit is preconfigured to 126 for
delivery.
How to determine and change the PROFIBUS address of the com unit is
described in the FAQs (section 6.3).
Please skip the following section and continue with section "4.3
Parameterizing Com Units".
In this case, the PROFIBUS address of the
com unit was previously changed from 126
to 117. 117 must therefore also be specified
in the PLC and PACTware.
(Determining/Changing
PROFIBUS Address ->
FAQs)
15
Advertisement
Table of Contents
