Table of Contents
Advertisement
GETTING STARTED
Integrating Remote I/O Stations with Com Unit LB/FB8X09* / LB/FB8X05*
4.2.2. Add a Com Unit
1.
on LB/FB service bus → Disconnect to ensure that the connection to
the previously added interface is disconnected.
2.
on the LB/FB service bus and select Add device to add the com unit
being used:
3. Enter the servicebus address of the com unit. Upon delivery, the preset
service bus address of the com unit is 1.
How to determine and change the service bus address of the com unit is
described in the FAQs (section 6.3).
Please continue with the following section "4.3 Parameterizing Com
Units".
19
In this case, the service
bus address of the com
unit was previously
changed from 1 to 119
and must therefore also
be specified here with
119
(Determining/Changing
Service Bus Address ->
FAQs).
Advertisement
Table of Contents
