How Do I Change The Service Bus Address Of The Com Unit - Pepperl+Fuchs LB8 09 Series Getting Started

GETTING STARTED
Integrating Remote I/O Stations with Com Unit LB/FB8X09* / LB/FB8X05*

6.4. How Do I Change the Service Bus Address of the Com Unit?

When configuring via PROFIBUS (e.g., with PROFIusb from Softing), the service
bus address is changed as follows:
on Com unit → Parameter → Parameterization → Edit Device Data
(Offline) to connect:
When configuring via the service bus interface (e.g., with ICPCON), the service
bus address is changed as follows:
1. on Service Bus Interface LB/FB Series → Connect to connect.
2. Scan the service bus:
Service Bus Interface LB/FB Series → Additional Functions →
Scan Service Bus:
Scan over a sufficient range
34
In contrast to a
configuration via the
service bus, the service
bus address can be
changed via PROFIBUS in
PACTware at this point.
When configuring via the
service bus, the service
bus address is only
specified here to ensure
communication with the
com unit.
Changes are not
applied until "Store to
Device" is selected