Table of Contents
Advertisement
GETTING STARTED
Integrating Remote I/O Stations with Com Unit LB/FB8X09* / LB/FB8X05*
4.5. Configuring I/O Modules (PACTware)
At this point, the application-dependent parameters of the I/O modules can
already be set. However, it is recommended to first continue with section
4.6. to ensure that the integration was successful.
1.
on Module → Parameter → Parametrization → Edit Device Data
(Offline).
Various parameters can be set (e.g., line monitoring).
Consult the com unit manual for more information.
2. Now save your changes with Save and OK.
At this point, line fault detection (LFD) should be deactivated to prevent line
fault messages appearing for unoccupied channels of the I/O modules: Com
unit → Disconnect.
Then: Com unit → Additional Functions → LFD of All Channels OFF. This
can be reactivated at a later point in time.
3. To apply the changes,
data in the com unit.
on Com unit → Store to Device to load the
23
Advertisement
Table of Contents
