Table of Contents
Advertisement
GETTING STARTED
Integrating Remote I/O Stations with Com Unit LB/FB8X09* / LB/FB8X05*
3.3. Configuring the Remote I/O Station
1. In the HW Config, add your com unit to your project by dragging and
dropping it on to the PROFIBUS line. This is located on the right in the
folder structure under PROFIBUS-DP → Additional FIELD DEVICES → I/O
→ "LB/FB 8X05H/DPV1 V6" for com units LB8105 and FB8205 or "LB/FB
8X09 Remote I/O 2" for com units LB8109 and FB8209. Now enter the
desired PROFIBUS address and confirm this window and the following
window with OK:
This creates an empty station with the corresponding PROFIBUS address.
The modules are now added as follows:
2. Click on the com unit to select it. You will now see a table for the various
components of the I/O station underneath the graphic representation of
your project:
Drag and drop
Table for
components
8
Advertisement
Table of Contents
