Table of Contents
Advertisement
GETTING STARTED
Integrating Remote I/O Stations with Com Unit LB/FB8X09* / LB/FB8X05*
4.
Configuration of the PROFIBUS Slave
Unicom com units (LB/FB 8X09) and type LB/FB8X05 com units must be
parameterized via PACTware. Before carrying out the following instructions, ensure
that PACTware and the DTM Collection have been installed correctly (see section 2).
The following description relates to PACTware version 4.1.
Two different ways to configure the remote I/O station are described below:
Via PROFIBUS using a PROFIBUS class 2 master (e.g., Softing
PROFIusb)
Via the service bus interface using a USB-RS485 converter (e.g., ICPCON
i-7561) with a suitable cable set (for LB item no. 541037, for FB item no.
541038)
Preferably, the configuration should be performed using a PROFIBUS class 2
master, as this offers a high transfer rate.
Depending on which of the two options is chosen, continue with the
corresponding section:
Via PROFIBUS using a PROFIBUS class 2 master: Section 4.1
Via the service bus interface using a USB-RS485 converter: Section 4.2
12
Advertisement
Table of Contents
