Advertisement
Available languages
Available languages
Check the status of the "Active" LED.
3.
In the hypothetical scenario that the LEDs are not displaying as
indicated in the previous section or that the device has been
previously configured, you will need to reset the configuration:
a
Press and hold the "RELOAD" button for 5 seconds.
Use a pointed (not sharp) tool to press the button
correctly.
b. Tap the "Next" button to proceed to the next step.
Smartlink mode.
4.
This smart-pairing mode works with 2.4 GHz Wi-Fi networks.
For 5 GHz networks, pairing must be carried out by directly
accessing the 485/WIFI 24H EQX2-T communication module.
Choose one of the following two options depending on the
specifications of the router in the installation:
4.1. Configuration for devices connected to 2.4 GHz Wi-Fi
networks.
If the status of the LEDs is correct, activate the SMARTLINK
function to pair the smartphone or tablet with the device:
a
Press and hold the "RELOAD" button for 1 second.
Use a pointed (not sharp) tool to press the button
correctly.
b. The NET LED will begin to flash.
c. Proceed to page 23, step 5 (Connecting the device).
4.2. Configuration for devices connected to 5 GHz Wi-Fi
networks.
If the status of the LEDs is correct, access the internal
configuration of the device:
Connect the smartphone, tablet or computer to be
a.
configured to the Wi-Fi network generated by the 485/
WIFI 24H EQX2-T communication module itself.
The network identifier (SSID) to connect to is indicated on
the module on the same label as the QR code.
In the list of available networks, it will appear as AP
(Access Point), followed by the serial number of the device.
QUICK GUIDE
5 sec.
a
1 sec.
a
SN: 0123456789
SSID: AP_0123456789
PWD: abcd123
EQUINOX - PHOTOVOLTAIC INVERTERS -
61
Advertisement
