Advertisement
Available languages
Available languages
The pairing process consists of 5 steps:
Adding the device.
1.
a
Tap the "Scan" button.
Your smartphone or tablet may ask for permission
to use the camera. You must give permission.
b. Hold the camera over the QR code on the device's label. The
scanner will close when the code is detected, and the serial
number will be displayed automatically.
Check that the serial number corresponds to the one on the
label.
SN: 0123456789
SSID: AP_0123456789
PWD: abcd123
Fig. 3. Example of a QR identification label
If you do not have a camera or it does not detect the QR code
correctly, enter the serial number manually in the field provided.
c
Tap the "Scan" button.
Two situations can occur when adding the device:
First: The device is added correctly. This is indicated by the
following message:
Second: The device you are trying to add has already been
registered. This is indicated by the following message:
Check status.
2.
This is a verification step. It requires the user to check that the
installation is correct.
The first time the 485/WIFI 24H EQX2-T communication
a.
module is powered, its LEDs should appear as follows:
Failing this, you will need to carry out step number 3.
Tap the "Next" button to proceed to the next step.
b.
60
LED off
LED flashing
LED on
a
c
SALICRU
Advertisement
