Commissioning - Triton OMNICARE GEOSRP81 Manual

INSTALLATION
Step Step
9

COMMISSIONING

Make sure that the electricity supply to the unit and isolating switch has been turned off
before proceeding.
Step Step
Remove the front cover and disconnect the PCB cable from the rear cover PCB then remove
9-1
the right hand trimplate.
Turn the water supply to the unit on and turn the bleed screw approximately 3 turns out
Step Step
- make sure that an absorbent cloth is in place to catch any purged water. Let the water
9-2
flow approximately 30-60 seconds until a steady stream of water flow with no bubbles
then re-tighten the bleed screw. Turn the water supply back off.
Step Step
9-1
Step Step
9-2
20
Turn bleed
screw 3
turns out
Open