Table of Contents
Advertisement
5.3.3 IP Filtering
IP Filtering is used to deny LAN users from accessing the public IP address on internet as shown in
To begin blocking access to an IP address, enable IP Filtering and enter the IP address of the web site you wish
to block.
Object
IP Filtering
Add IP Filtering Rule
Object
Enable
Type
Source IP Address
Anywhere (of source IP Address)
Destination IP Address
Anywhere (of destination IP Address)
Destination Port
Protocol
Figure 5-40: IP Filtering
Set the function as enable or disable.
Go to the Add Filtering Rule page to add a new rule.
Figure 5-41: IP Filter Rule Setting
Set the rule as enable or disable.
Set the type as IPv4 or IPv6
Input the IP address of LAN user (such as PC or laptop) which you
want to control.
Check the box if you want to control all LAN users.
Input the IP address of web site which you want to block.
Check the box if you want to control all web sites, meaning the LAN
user can't visit any web site.
Input the port of destination IP Address which you want to block.
Leave it as blank if you want to block all ports of the web site.
Select the protocol type (TCP, UDP or all).
If you are unsure, please leave it to the all the default protocols.
-59-
User Manual of WDAP-C7210E
Description
Description
Figure
5-40.
Advertisement
Table of Contents
