Table of Contents
Advertisement
Object
IP Address
Subnet Mask
DHCP Server
DHCP Fallback
(AP mode only)
Fallback Seconds
(AP mode only)
Start IP Address
Maximum DHCP Users
Next
Cancel
Step 3: WAN Interface
The router supports two access modes on the WAN side shown in
Enter the IP address of your router. The default is 192.168.1.1.
An address code that determines the size of the network. Normally
use 255.255.255.0 as the subnet mask.
By default, the DHCP Server is enabled.
If user needs to disable the function, please uncheck the box.
The IP address of your AP will be assigned from DHCP Server. If there
is no DHCP Server in the local network, the IP will be set to
192.168.1.253.
By default is 60
By default, the start IP address is 192.168.1.100.
Please do not set it to the same IP address of the router.
By default, the maximum DHCP users are 101, which means the router
will provide DHCP client with IP address from 192.168.1.100 to
192.168.1.200 when the start IP address is 192.168.1.100.
Press this button to the next step.
Press this button to undo any changes made locally and revert to
previously saved values.
Figure 5-8: Setup Wizard – WAN 1 Configuration
-31-
User Manual of WDAP-C7210E
Description
Figure 5-8
Advertisement
Table of Contents
