Ip Filtering - Planet WGR-500-4P User Manual

4.4.4

IP Filtering

IP Filtering is used to block internet or network access to specific IP addresses on your local network as shown in
Figure 4-41. The restricted user may still be able to log in to the network but will not be able to access the internet.
To begin blocking access to an IP address, enable IP Filtering and enter the IP address of the user you wish to
block.
Object
Enable IP Filtering
Enable IPv4
Enable IPv6
Local IP Address
Protocol
Comment
User's Manual of WGR-500-4P and WGR-500-4PV
Figure 4-41: IP Filtering
Check this box to enable IP Filter function
Check this box to enable IP filtering method using IPv4.
Check this box to enable IP filtering method using IPv6.
Add LAN IP address you want to control
Select the port number protocol type (TCP, UDP or both).
If you are unsure, then leave it to the default both protocol
Enter the description for this setting.
73
Description