ClearOne Tabletop Controller User Manual page 22

METER TYPE DEFINITIONS
SERIAL COMMAND ERROR CODES
Error n n umber
1
2
3
4
5
6
7
8
10
11
12
22 Technical Services: 800.283.5936
Text m m essage
Memory error
No command found
Unknown command
Not implemented
Argument error
Unknown command
Bad checksum
Preset of macro invalid
Queue error
Command too big
Unit is locked
Explanation/Solution
The box is out of internal memory. Power cycle the box.
A command was not found in the string.
A command was executed on a different device type that this
box cannot display. The command dictionary needs to be
updated.
The command is not implemented.
The command had an argument that was out of range.
The command is unknown to this unit.
The binary command's checksum is wrong.
A preset or macro failed to program because it is too large or
because its command list contained an invalid command.
The internal command queue is full. Enable flow control and use
all five pins on the serial port.
The binary command is too large.
Unlock the unit with the proper password.
Meter type definitions
FIGURE 5.2