Network - ICPDAS DL-100-E User Manual

The Digital Output table shows the status of the relay output and the control button Set
Digital Output to change the relay output status. The control function is invalid when
any of the alarm modes is not disabled. If one of the alarm modes is enabled, the relay
is linked to the alarm status for tapping audible/visual alarm. The Digital Output table
is only available to the DL-101-E.
At the end of the page are the data, time and device online time since powered on.

3.4 Network

The networks parameters are set on this page including DHCP enabled/disabled,
IP/Subnet Mask/Gateway addresses, the port number and the NetID for Modbus TCP
communication. Remember to click on the Update Settings button to update new
parameters.
DL-100-E / DL-101-E / DL-110-E / DL-120-E User Manual Version 1.1.3 Dec 2020 - 23 -