Don't Void Your Warranty; Before You Install The Camera; Cabling Notes - LEGRAND VADDIO RoboSHOT 30E-M Installing

Connections
This section covers:
Selecting the location for the camera
n

Cabling notes

n
Connection diagrams
n

Don't void your warranty!

Caution
This product is for indoor use. Do not install it outdoors or in a humid environment without the appropriate
protective enclosure. Do not allow it to come into contact with any liquid.
Do not install or operate this product if it has been dropped, damaged, or exposed to liquids. If any of
these things happen, return it to Vaddio for safety and functional testing.

Before you install the camera

Keep these things in mind when deciding where to place the camera.
Consider camera viewing angles, lighting conditions, line-of-sight obstructions, and in-wall
n
obstructions where the camera is to be mounted.
Prepare for a successful installation:
Be sure you can identify all cables correctly.
n
n If you make cables for this installation, check them for continuity.
n Talk to the network administrator. If installing the camera in a non-DHCP network (one that does not
automatically assign IP addresses), you will need to configure the camera with a static IP address as
directed by the network administrator.
Cabling notes
Caution
Do not use pass-through RJ-45 connectors when making cables for this product. Poorly
crimped connectors of this type can cause intermittent connections and degraded signal
quality. They can also damage the connectors on the product, which will void your warranty.
Intact – will make reliable contact
with cable connector
When making cables for this product, use Cat-5e or better cable. We recommend using high-quality
connectors and a high-quality crimping tool.
We recommend shielded cabling if the cables will be coiled, run tightly with other cables, or routed near
sources of electromagnetic interference such as power lines or fluorescent light fixtures.
Caution
Check your cables. Connecting a cable to the wrong port or using the wrong pin-out can result in
equipment damage and will void the warranty.
Pro Tip
Label all cables at both ends.
Installation Guide for the RoboSHOT 30E-M PTZ Camera
4
Damaged – Bent contact fingers
will NOT make reliable contact
with cable connector