Table of Contents
Advertisement
OnBoard Serial PortA/
PortB
Serial Port B Mode Allows you to set serial Port B Mode.
IR Duplex Mode Select the value required by the IR device connected
IR Pin Select This item allows you to enable the TX, RX inverting
OnBoard Parallel Port Allows you to configure parallel port on board.
Parallel Port Mode If Parallel Port is not disabled, this option allows
EPP Version Select EPP port type 1.7 or 1.9.
Allows you to set Serial Port on board. Select a logi-
cal COM port name and matching address for
the first and second serial ports. Select an
address and corresponding interrupt for the
first and second serial ports.
The choices: Auto; Disable; 3F8h/COM1;
2F8h/COM2; 3F8h/COM3; 2F8h/COM4
The choices: Auto; Normal; IrDA; ASKIR
to the IR port. Full-duplex mode permits simultaneous
two-direction transmission. Half-duplex mode per-
mits transmission in one direction only at a time. If
no infrared port is present in the system, select
Disabled.
which depends on different H/W requirement. This
field is not recommended to change its default
setting for avoiding any error in your system.
The choice: "No, No", "No, Yes"(default), "Yes, No",
"Yes, Yes".
The choices: Auto; Disabled; 378h; 278h; 3BCh
you to configure parallel port mode.
The choices: SPP; EPP; ECP; EPP+ECP
69
Chapter 4 BIOS Setup
Advertisement
Table of Contents
