Table of Contents
Advertisement
Tighten the seal head/air piston to 28 N·m (248 in-lb).
8
Install the crowfoot onto the torque wrench at a 90° angle to the
handle to ensure an accurate torque reading.
Remove the shock from the vise. Turn the shock over and clamp the
9
shaft eyelet into the vise.
Slowly push the damper body downward. Fluid will begin to fill the
10
reservoir through the IFP bleed port. Stop when the damper body is
3/4 of the way through the travel.
⚠ CAU T ION- E YE HAZARD
Do not look directly into the reservoir as you push on the damper body.
Fluid may be ejected from the IFP reservoir if you push the damper
down to fast. Wear safety glasses.
Pour RockShox® 7wt suspension oil into the IFP reservoir until it is level
11
with the top of the reservoir.
19 mm
7wt
Shock Assembly and Bleed
28 N•m (248 in-lb)
29
Advertisement
Table of Contents
